GerätePV hybrid and battery invertersHYXiPOWER
Unterstützte Geräte
| Device Type | Variants | Manual | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|---|---|
| All In One ESS | HYX-H6K-HTA | Manual | ❌ | ✅ | ✅ |
| HYX-H9K-HTA | |||||
| HYX-H12K-HTA | |||||
| HYX-H15K-HTA |
Verkabelung
RS485
Für die RS485-Verkabelung verwenden Sie den COM-Port (Nr. 5) am Wechselrichter.
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | A-tronix Controller model OM1 | A-tronix Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 A (Pin 5) | RS485 A | RS485_POS | RS485 A | TX+ |
| RS485 B (Pin 6) | RS485 B | RS485_NEG | RS485 B | TX- |
| N/A | RS GND | GND | Not available | G |
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the A-tronix Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The A-tronix Controller will scan on those first.