الأجهزة المدعومة
| Device Type | Variants | Manual | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|---|---|
| محول هجيني Inverter | HYX-H5K-HT | Manual | ❌ | ✅ | ✅ |
| HYX-H6K-HT | |||||
| HYX-H8K-HT | |||||
| HYX-H10K-HT | |||||
| HYX-H12K-HT | |||||
| HYX-H15K-HT | Manual | ||||
| HYX-H20K-HT | |||||
| HYX-H25K-HT |
التوصيل الكهربي
RS485
لتوصيل RS485، استخدم منفذ الاتصال المحجوز (رقم 14) في المحول.
معلومات
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | a-TroniX Controller model OM1 | a-TroniX Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 A (Pin 5) | RS485 A | RS485_POS | RS485 A | TX+ |
| RS485 B (Pin 6) | RS485 B | RS485_NEG | RS485 B | TX- |
| N/A | RS GND | GND | Not available | G |
تحذير
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the a-TroniX Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The a-TroniX Controller will scan on those first.